According to French drains Downriver Michigan specialists, you have to ensure that any excess fat from the cooking goes into a separate container rather than down the drain.
The most common cause of blocked kitchen drains the accumulation of congealed oil from deep fat fryers and other things such as food and plastics.
Generally, you have to remove the plughole for a standard-shaped drain unscrewing it and cleaning it well with the limescale remover and sponge. Then, look through the plughole to check if there are any clear blockages that you can manually remove.
It would be effective to wipe away any moisture once the area was clear.
Suppose the blockage was removed, run the taps to determine if the sink drains properly. Then, place the plunger’s bottom over the plughole and firmly press down.
After you are finished, open the taps for a few seconds until there’s a couple of inches of lukewarm water around the seal of the plungers.
Using both hands on the plunger handle, vigorously push it up and down to produce suction.
With any luck, you’ll be able to loosen the obstruction and hear a sound of thankful gurgling from the grateful sink.
The difficulty occurs when the u-bend in the sink needs to be cleared. You can follow these simple steps below to deal with this issue.
Step 1:
First and foremost, change into clothes you don’t mind being wet. This will be a dirty task, so don’t wear your Sunday best and make sure you have your rubber gloves on.
After that, place some towels beneath the sink to absorb any extra water. Remember to preserve one of the towels for a headrest if you’ll be under the sink for an extended time.
Finally, position the bucket beneath the u-bend.
Step 2:
Using your wrench, slowly loosen the threaded caps from each side of the u-bend and guide any rushing water into the bucket. It would be best if you carry the u-bend to another sink or an outside area where you can clean it with water.
Use the antibacterial spray and sponge to thoroughly clean the u-bend at this stage because the bacteria have most likely been present there for quite some time.
Step 3:
Reattach the u-bend with the wrench and run the cold tap slowly to ensure that it is adequately sealed.
Hopefully, there will be no leaks, and you will be able to remove the towels and bucket. If you find a leak, try disconnecting and reconnecting the u-bend.
