|
| ||||||||||||||||||
 |  |  |  |  |  |  |  |  |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
29th September 2011, 06:57 AM
| #1 |
| I'm new here so be nice Join Date: Sep 2011 Location: Zion
Posts: 1
|  Sthil HT75
My HT75 wont idle but it runs fine when i start it holding the trigger cleaned carb and new plug any help plz
|
|  |
|
29th September 2011, 09:06 PM
| #2 |
| Semi-mature vigorous tree Join Date: Aug 2010 Location: Perth, WA
Posts: 238
| Re: Sthil HT75
idle could be low or seals could be shot....
|
|
| |
|
1st October 2011, 04:30 PM
| #3 |
| Semi-mature vigorous tree  Join Date: Sep 2011 Location: Oregon
Posts: 100
|  Re: Sthil HT75
Check your fuel line and impulse first then check the exhaust outlet.  |
|
| |
|
4th October 2011, 08:58 AM
| #4 |
| Mature tree Join Date: Jul 2010 Location: Adelaide SA
Posts: 292
| Re: Sthil HT75
Just a thought; if the tabs have been removed from the jet screws, the screws tend to vibrate out, thus rich up the mix. If so, they just need to be re-set. The settings are marked on the orange plastic housing near the carb. Happens to my blower all the time  |
|
| |
|
10th October 2011, 11:33 PM
| #5 | |
| Sappling Join Date: May 2010 Location: brisbane
Posts: 12
| Re: Sthil HT75 Quote:
So i just ordered a new carburetor from the states, hope i will get it next week | |
|
| |
|
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stihl HT75 Polesaw | MrDiesel | Chainsaws | 5 | 14th October 2010 08:47 AM |
| ht75 sprocket replace | MTS247 | Chainsaws | 3 | 8th August 2010 01:39 PM |
| Sthil 064 great saw/or not even close to a MS660 | Stubs 0072 | Chainsaws | 1 | 27th February 2010 02:50 AM |
| Need Help with Sthil MS 210 Auto Oiler | David Bradley | Chainsaws | 8 | 14th January 2010 12:03 PM |
| My Sthil's | Cole | Chainsaws | 54 | 22nd November 2009 12:24 AM |
Linear Mode
