 Re: One Handed Chainsawing
I didn't notice this thread untill now. I use my MS 200T with one hand too. BUT...
-when operating one handed I make sure that the saw, even in the event of kickback can never ever touch any part of my body or gear.
-when operating one handed, I wear these chainsaw cut-resistant sleeves that cover my forearm and elbow and a part of the upper arm.
-When operating one handed, I always have a setup that allows me to get to the ground real quick with one hand. So never ever have to change anything about the setup, just unbuckle the flipline, and pull the knot or the handle of the descender.
-any top handled chainsaw of mine is in mint condition, but ya'll already know that I do care for all of my gear. when something breaks, like the chainbrake system or chain catcher or something else, they go back into the van and go straight to a service center. But I have these critical spare parts box, wich allows us to service it on site for critical break-down parts.I have these parts for all of my saws.I have chain catchers, plastic chainguidance blocks, chainbrake systems, chains, a bar, ....
-When blocking down, it happens that i cross over the bar with the forarm, in the event of not using the step cut. Protective sleeves are being used then.
EVERY TIME...
-I never operate one handed near the upper body or face.
I never ever use a rear handle chainsaw one-handed, unless I simply have to hold it with the chainbrake on. I never allow a groundie to use a top handle chainsaw, that's why we use the MS 200 (regular, not T version) for clean-up on the ground.
I do believe that a MS 200T can be used safely with one hand.When operated correctly, it can be great sometimes. I also believe, that it would be a good thing to ask for arb certification when the saw is purchased. |