Quote:
|
Originally Posted by shaggs ANYONE DONE ANY GOOD MODS LATLEY???? |
Here's a mod from a couple different angles.
First, the .325 sprocket was removed and a 3/8, 8-pin sprocket put on.
The 16" .325 .050 bar was offed and replaced by a 14" hard nose titanium bar so we can run
the 3/8" thinner kerf chain like on the top-handle saws.
The muffler mod my guy put in is recessed back in, hard to see, but seeing it really isn't the point.
This new saw is the same setup I've been running for 2 years on my current aerial partner. It's my personal preference for
a climbing saw, you can get a
lot of cutting done on a single tank of gas.